CCNA Discovery 3 Module 9 Exam Answers Version 4.0

CCNA Discovery 3 Module 9 Exam Answers Version 4.0

1. • 172.16.3.0
2. • There are congestion problems on the network.
3. • The line protocol of the local router is now up.
4. • The IP address of each subinterface must be the default gateway address for each VLAN subnet.
5. • No clock rate has been set on the DCE interface.
6. • The VTP domain names are different.
7. • Check the log to see what software components are producing the excess traffic.
8. • The packet is routed to R1 and then forwarded out Fa0/0 on R1.
9. • VLSM is not supported by RIPv1.
10. • The destination host address in an ACL statement is incorrect.
11. • divide-and-conquer
12. • The command was entered on router R1.
13. • The ACL is applied to the wrong interface, but the right direction.
14. • It will show network 172.16.3.0 learned from RB.
15. • large failure domain • single point of failure.
16. • password mismatch for PPP authentication
17. • The router interface is in the wrong subnet.
18. • The EIGRP process number on R2 is incorrect.
19. • Port 0/4 is configured in access mode.20.
20. • There is an addressing problem on the link between routers R2 and R3.
21. • Workstation 1 is not on the same network that the RTA router LAN interface is on.
22. • It should be performed when all switch Cisco IOS versions are upgraded dan • It should be done when the network is performing at normal activity levels.